Description
Tool Length Sensor CNC Rebuild WLS 1 (8 mm)
8 or 14 mm: Which WLS do I need? |
With a small machine table, every square inch of clamping surface often counts. In most cases, smaller milling cutters up to max. Ø 6 mm are used here. Then the small tool length sensor is recommended.
However, larger milling cutters also require a larger sensor probe. Since the cutting edges to be measured are on the outside of the radius, they would sink past a button that is too small. Here it must be the 14 mm variant. |
The tool length sensor consists of a high quality aluminium body, precisely turned and milled, a low-wear stainless push-button and a built in microswitch. It is equipped with a 3 core cable and can thus be connected as normally closed or normally open.
Technical Specification:
- Overall height: 34 mm
- Diameter: 34 mm
- Diameter push-button: 8 mm
- Cable length: 3 m
- Mounting: 2 x M4 Screws