Description

Triple BEAST

All-In-One Breakoutboard and three Stepper drives in a compact housing of only 100 x 102 x 55mm

Runs with Step/Dir driven Software like fpr example USB-CNC, Mach3, EMC², CNCProfi, WinPC-NC and similar CNC-software
Quick and easy mounting on a rail, Cabling within minutes ready to run
For 2-Phase-Stepper Motors from 1,4 to 5A, 42 bis 86mm (NEMA17 to 34)
Power supply 24 bis 55V. Only one Power supply necessary
Integrated protection against short circuit, overtemperature and overvoltage caused through braking energy
Very quiet operation with sinusoidal waveform
No compromise between vibration and possible speed needed, In 1/5 or 1/10 Micro Stepping the motors run as smoothly as with 1/64 microstepping or better. This means that no high frequencies are necessary
Made in Germany. Complete development and production in Germany
Connection option for fourth axis with an external Stepping drive.
Two relays for switching loads (spindle motor, coolant, vacuum, etc.)
4 inputs for reference switches (mechanical or inductive), 1 Emergency stop
Watchdog (charge pump) prevents movements of machine during booting of PC or when software not active.
0. .10 V analog output for speed control (frequency converter)
high efficiency, minimal warming of drives and motors

Important:
For the operation of the current Version of the Triple Beast with EDINGCNC an adaptation board is needed. These can be found here.

Also available as a cost efficient DriveSet